Timestamps

0:00 Introduction
0:19 Contextual toolbar - purposes
0:27 Contextual toolbar – maximise and pin to a location
0:44 Grid setup
1:14 Leg (vertical) creation - Tube Connector tool
1:30 Leg insertion with an offset from the ground – Temporary snapping
2:02 Interrupt a command from running
2:05 Baseplate creation from a leg (tube)
2:40 Rotation of the baseplate 
2:49 Copying one leg forming a bay width - Copy command
2:53 Selection of multiple objects with Control
3:16 Selection of multiple objects by Window select
3:27 Copying multiple legs by number of copies forming a bay - Copy Special > Linear command
3:58 Ledgers creation – Tube and Clip tool insertion
4:23 Add extra couplers – Add Connection feature of the Tube and Clip tool
4:34 Tube extension - Tube and Clip tool tube end handler
4:47 Add ledgers with joiners using Copy command from the Tube and Clip tool
5:15 Copying ledgers to other side of the bay - Copy command
5:34 Flipping tubes and couplers over a leg – Flip command of the Tube and Clip tool
6:01 Transom creation - Tube and Clip tool
6:40 Forming a first lift – Copy Special > Linear command
6:59 Guardrails along the bay creation - Tube and Clip tool
7:11 Guardrails creation on a side of the bay – ScaffPlan Smart Copy command 
7:33 Guardrails copying - Copy Special > Linear command
7:40 Flipping multiple guardrails to the other side of the bay – Flip command of the Tube and Clip tool
7:57 Putlogs creation - Tube and Clip tool
8:19 Copying putlogs by number of copies - ScaffPlan Smart Copy command
8:38 Timber planks (decking) creation - Selection of a component in the Tube and Clip tool and Item tool Create command
9:22 Changing of the timber planks length – Item tool Profile command
9:44 Copying planks along the bay to form the deck - Item tool Copy the same object from an end command
10:08 Distribution of putlogs along the deck – ScaffPlan Smart Copy and Move commands 
10:54 Retention clips creation - Item tool Create command
11:10 Copying retention clips along the deck - Item tool Copy to another object command
11:34 Toe boards creation – Item tool Create command
12:08 Add tube and coupler holding boards - Tube and Clip tool
12:27 Creation of putlog couplers for a board retention – Item tool: Create, swap handlers and rotation commands
12:54 Crate an extra lift (copy a lift) – Copy Special > Linear command
13:13 Side bracing creation - Tube and Clip tool
13:29 Flipping a brace to the other side of the bay – Flip command of the Tube and Clip tool
13:33 Moving a brace end to resolve a clash - Tube and Clip tool end handler 
13:40 Coping brace along the bay - Copy command
13:53 Face bracing creation - Tube and Clip tool 
14:10 Extend the face bracing – Copy with a joiner command of the Tube and Clip tool
14:25 Adjusting led tubes to suit scaffold height – Tube 1 and Tube 2 length control of the Tube Connector tool
14:41 Outro