1. Purpose of the feature.

From ScaffPlan 1.7 it is possible to to add console brackets at a bay end or ends..

Console brackets at ends creation feature is available on the contextual toolbar and also in the bay tool menu under the console brackets drop down.

Please see a video example on the console brackets at ends:

Bay tool: Console Brackets at Bay Ends

2. Creation of console brackets at a bay ends.

Console brackets might be added at a bay End1 or End2.

To create a console bracket at End1 the bay (the same is applicable to the End2):

1. Select the bay where the console bracket is required.
2. On the contextual toolbar enable Console brackets creation by selecting Yes in the drop down.
3. Remove brackets from Inner, Outer, End2 sides if were set previously.
4. Optional: Lock a bay side to be static (stop the bay from moving off the wall on the console creation) - set Position to End1 in this case.
5.  In the End1 console brackets drop down select a console size required.
6. The brackets will be created. 

The same might be done for the End2 of the bay but the Lock and Selection of the bracket size needs to picked for the End2 respectively.